Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide show ap mesh debug provisioned-clusters | 673
show ap mesh debug provisioned-clusters
show ap mesh debug provisioned-clusters {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr
<ip-addr>}
Description
Show cluster profiles provisioned on a mesh portal or mesh point.
Syntax
Example
The output of the command below shows statistics for the AP’s mesh cluster profile and recovery cluster profile.
The output of this command displays the following information for the AP’s mesh cluster profile and recovery
cluster profiles:
Parameter Description
ap-name <ap-name> Show data for a mesh node with a specific name.
bssid <bssid> Show data for a mesh node with a specific Basic Service Set Identifier (BSSID). The Basic
Service Set Identifier (BSSID) is usually the AP’s MAC address.
ip-addr <ip-addr> Show data for a mesh node with a specific IP address by entering an IP address in dotted-
decimal format.
Column Description
Cluster Name Name of the mesh cluster using this profile
RF band The RF band in which the AP should operate:
z g = 2.4 GHz
z a = 5 GHz
(host) #show ap mesh debug provisioned-clusters ap-name portal2
AP Portal Cluster Profile: mesh-cluster-profile
-------------------------------------------------
-------------------------
Parameter Value
--------- -----
Cluster Name sw-ad-GB32
RF Band a
Encryption opensystem
WPA Hexkey N/A
WPA Passphrase ********
AP "Portal" Cluster Profile: Recovery Cluster Profile
-----------------------------------------------------
Item Value
---- -----
Cluster Name Recovery-ZF-xAPl5z-g15VN
RF Band a
Encryption pa2-psk-aes
WPA Hexkey ********
WPA Passphrase N/A