Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide show ap mesh neighbors | 675
show ap mesh neighbors
show ap mesh neighbors {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-addr>} [names]
Description
Show all mesh neighbors for an AP.
Syntax
Example
In the example below, the output has been split into two tables to better fit on the page. In the actual command-
line interface, the output appears in a single, wide table. The Flags column the output of this command indicates
the high-throughput (HT) properties of the mesh node. In the example below, the string “HT-40MHzsgi-2ss”
indicates that the node uses a 40MHz channel with a short guard interval (sgi) and sends 2 spatial streams (ss).
The output of this command includes the following information:
Parameter Description
ap-name <ap-name> Show mesh neighbors for an AP with a specific name.
bssid <bssid> Show mesh neighbors for a specific Basic Service Set Identifier (BSSID) on an AP. The Basic
Service Set Identifier (BSSID) is usually the AP’s MAC address.
ip-addr <ip-addr> Show mesh neighbors for an AP with a specific IP address by entering its IP address in dotted-
decimal format.
names If you include this optional parameter, the Portal column in the output of this command will
translate the BSSIDs of mesh parent and child APs to AP names (where available).
(host) #show ap mesh neighbors ap-name portal
Neighbor list
-------------
MAC Portal Channel Age Hops Cost Relation Flags RSSI Rate Tx/Rx
--- ------ ------- --- ---- ---- -------- ----- ---- ----------
00:0b:86:e8:09:d1 00:1a:1e:88:01:f0 157 0 1 11.00 C 3h:15m:42s - 65 54/54
00:1a:1e:88:02:91 00:1a:1e:88:01:f0 157 0 1 4.00 C 3h:35m:30s HL 59 300/300
00:0b:86:9b:27:78 Yes 157 0 0 12.00 N 3h:22m:46s - 26 -
00:0b:86:e8:09:d0 00:1a:1e:88:01:f0 157 0 1 11.00 N 3h:15m:36s - 65 -
00:1a:1e:88:02:90 00:1a:1e:88:01:f0 157+ 0 1 2.00 N 3h:35m:6s HL 59 -
A-Req A-Resp A-Fail HT-Details Cluster ID
----- ------ ------ ---------- ----------
1 1 0 Unsupported sw-ad-GB32
1 1 0 HT-40MHzsgi-2ss sw-ad-GB322
0 0 0 Unsupported mc1
0 0 0 Unsupported sw-ad-GB32
0 0 0 HT-40MHzsgi-2ss sw-ad-GB32
Total count: 5, Children: 2
Relation: P = Parent; C = Child; N = Neighbor; B = Blacklisted-neighbor
Flags: R = Recovery-mode; S = Sub-threshold link; D = Reselection backoff; F = Auth-failure; H = High Throughput; L =
Legacy allowed
Column Description
MAC MAC address of the mesh node.