Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide am | 85
am
am scan <ipaddr> <channel> [bssid <bssid>]
am test <ipaddr> {suspect-rap bssid <bssid> match-type <match-type> match-method
<method>|wired-mac {add|remove {bssid <bssid>|enet-mac <enet-mac>} mac <mac>}
Description
These commands enable channel scanning or testing for the specified air monitor.
Syntax
Usage Guidelines
These commands are intended to be used with an Dell AP that is configured as an air monitor. You should not
use the am test command unless instructed to do so by an Dell representative.
Example
The following command sets the air monitor to scan all channels:
(host) (config) #am scan 10.1.1.244 0
Parameter Description Range
scan IP address of the air monitor to be scanned. —
<channel> Channel to which the scanning is tuned. Set to 0 to enable
scanning of all channels.
—
bssid BSSID of the air monitor. —
test IP address of the air monitor to be tested. —
suspect-rap Tests suspect-rap feature. —
match-type Match type. eth-wm | ap-wm | eth-gw-wm
match-method Match method. equal | plus-one | minus-one
wired-mac Tests the rogue AP classification feature.
Specifies the Wired MAC table.
—
enet-mac Specifies the Ethernet MAC table. —
mac Specifies the MAC entry to add/remove from either the
Wired MAC table or the Ethernet MAC table.
—