Reference Guide

Table Of Contents
876 | show interface vlan Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
show interface vlan
show interface vlan
Description
Displays information about a specified VLAN interface.
Syntax
No parameters
Example
The example below shows the output of show interface vlan 1on a W-600 Controller Series controller.
The output of this command includes the following parameters:
Parameter Description
VLAN1 is... Status of the specified VLAN
line protocol is... Displays the status of the line protocol on the specified port
Hardware is... Describes the hardware interface type
Interface address
is...
Displays the MAC address of the hardware interface
Description Description of the specified VLAN
Internet address
is...
IP address and subnet mask of the specified VLAN
Routing interface
is...
Status of the routing interface
Forwarding mode is... Status of the forwarding mode
Directed broadcast
is...
Displays whether or not directed broadcast is enabled
Encapsulation Encapsulation type
loopback... Loopback status
MTU MTU size of the specified port in bytes
Last clearing of
“show interface
counters”
Time since “show interface counters” was cleared
link status last
changed
Time since link status last changed
Proxy ARP is... Status of proxy ARP on the specified interface
#show interface vlan 1
VLAN1 is up line protocol is up
Hardware is CPU Interface, Interface address is 00:0B:86:51:14:D0 (bia
00:0B:86:51:14:D0)
Description: 802.1Q VLAN
Internet address is 10.3.49.50 255.255.255.0
Routing interface is enable, Forwarding mode is enable
Directed broadcast is disabled
Encapsulation 802, loopback not set
MTU 1500 bytes