Reference Guide

88 | ap enet-link-profile Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
ap enet-link-profile
ap enet-link-profile <profile>
clone <profile>
duplex {auto|full|half}
no ...
speed {10|100|1000|auto}
Description
This command configures an AP Ethernet link profile.
Syntax
Usage Guidelines
This command configures the duplex and speed of the Ethernet port on the AP. The configurable speed is
dependent on the port type.
Example
The following command configures the Ethernet link profile for full-duplex and 100 Mbps:
ap enet-link-profile enet
duplex full
speed 100
Command History
Command Information
Parameter Description Range Default
<profile> Name of this instance of the profile. The name must be 1-63
characters.
— “default”
clone Name of an existing Ethernet Link profile from which
parameter values are copied.
——
duplex The duplex mode of the Ethernet interface, either full, half,
or auto-negotiated.
full/half/auto auto
no Negates any configured parameter. — —
speed The speed of the Ethernet interface, either 10 Mbps, 100
Mbps, 1000 Mbps (1 Gbps), or auto-negotiated.
10/100/1000/auto auto
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.3 Support for 1000 Mbps (1 Gbps) Ethernet port speed was introduced.
Platforms Licensing Command Mode
Available on all platforms Base operating system Config mode on master controllers