Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide show ipv6 datapath user table | 917
show ipv6 datapath user table
show ipv6 datapath user table
Description
Displays ipv6 datapath user table entries.
Example
This example displays the user table entries in the datapath.
The output of this command includes the following parameters:
Command History
This command was available in ArubaOS 3.0.
Command Information
(host) #show ipv6 datapath user table
Datapath User Table Entries
---------------------------
Flags: P - Permanent, W - WEP, T- TKIP, V - ProxyArp for User, A - ProxyARP to User, N - VPN
IP MAC ACLs Contract Location Age Sessions Flags
-- --- ---- -------- -------- --- --------- -----
fe80::216:ceff:fe2c:b485 00:16:CE:2C:B4:85 1/0 0/0 1 28 0/65535 W
2003:d81f:f9f0:1001:617c:9151:6d25:f754 00:16:CE:2C:B4:85 1/0 0/0 1 0 0/65535 W
Parameter Description
IP IP address of the user (client).
MAC MAC address of the user (client).
ACLs The access control list assigned to the user.
Contract Bandwidth contract.
Location This value refers to the AP-group of the IPv6 client. Use the show aaa state ap-
group to get the AP group and the location ID mapping.
Age Total time connected to the controller.
Sessions Number of active sessions.
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master and local
controllers