Reference Guide

1016 | show ids general-profile Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Debug Wireless Containment false
Wired Containment false
Wired Containment of AP's Adj MACs false
Mobility Manager RTLS false
IDS Event Generation on AP none
Send Adhoc Info to Controller true
The output of this command includes the following parameters:
Parameter Description
Stats Update Interval
Interval, in seconds, for the AP to update the controller with statistics. This
setting takes effect only if the Dell Mobility Manager is configured.
Otherwise, statistics update to the controller is disabled.
Monitored Device Stats Update
Interval
Time interval, in seconds, for AP to update the switch with stats for
monitored devices. Minimum is 60.
AP Inactivity Timeout
Time, in seconds, after which an AP is aged out.
Adhoc (IBSS) AP Inactivity
Timeout
Ad hoc (IBSS) AP inactivity timeout in number of scans.
AP Max Unseen Timeout
Ageout time, in seconds, since AP was last seen.
STA Inactivity Timeout
Time, in seconds, after which a station is aged out.
STA Max Unseen Timeout
Time, in seconds, after which an AP is aged out.
Min Potential AP Beacon Rate
Minimum beacon rate acceptable from a potential AP, in percentage of
the advertised beacon interval.
Min Potential AP Monitor Time
Minimum time, in seconds, a potential AP has to be up before it is
classified as a real AP.
Signature Quiet Time
After a signature match is detected, the time to wait, in seconds, to resume
checking.
Wireless Containment
Shows if the profile has enabled or disabled containment from the
wireless side.
Debug Wireless Containment
Shows if the profile has enabled or disable debugging of containment from
the wireless side.
Wired Containment
Shows if the profile has enabled or disable containment from the wired
side.
Wired Containment of AP’s Adj
MACs
Enable/disable wired containment of MACs offset by one from APs BSSID.
Mobility Manager RTLS
Shows if RTLS communication with the configured mobility-manager is
enabled or disabled.
IDS Event Generation on AP
Enable or disable IDS event generation from the AP. Event generation from
the AP can be enabled for syslogs, traps, or both. This does not affect
generation of IDS correlated events on the switch.
Send Adhoc Info to Controller
Enable or disable sending Adhoc information to the controller from the AP.