Reference Guide

104 | ap-group Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description Range Default
rf-optimization-profile
Configure coverage hole and interference detection.
See "rf optimization-profile" on page 540.
— “default”
virtual-ap
One or more profiles, each of which configures a
specified WLAN. See "wlan virtual-ap" on page 1512.
— “default”
voip-cac-profile
Configures voice over IP (VoIP) call admission
control (CAC) options. See "wlan voip-cac-profile" on
page 1520.
This parameter requires the PEFNG license.
— “default”
Usage Guidelines
AP groups are at the top of the configuration hierarchy. An AP group collects virtual AP definitions and
configuration profiles, which are applied to APs in the group.
Example
The following command configures a virtual AP profile to the “default” AP group:
(host)(config) #ap-group default
virtual-ap corpnet
Related Commands
View AP group settings using the command show ap-group.
Command History:
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.2 Support for the mesh parameters was introduced
ArubaOS 3.4.1 The voip-cac-profile parameter required the PEF license.
ArubaOS 5.0 The voip-cac-profile parameter requires the PEFV license.
ArubaOS 6.0 The enet-port-profile parameters parameters were introduced.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system, except for
noted parameters
Config mode on master controllers