Reference Guide

1052 | show interface tunnel Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
show interface tunnel
show interface tunnel
Description
Displays information about tunnel interfaces.
Syntax
No parameters
Example
The example below shows the output of show interface tunnel.
#show interface tunnel 2000
Tunnel 2000 is up line protocol is up
Description: Tunnel Interface
Internet address is 3.3.3.1 255.255.255.0
Source 192.168.203.1
Destination 192.168.202.1
Tunnel mtu is set to 1100
Tunnel is an IP GRE TUNNEL
Tunnel is Trusted
Inter Tunnel Flooding is enabled
Tunnel keepalive is disabled
he output of this command includes the following parameters:
Parameter Description
Tunnel 2000 is...
Status of the specified tunnel.
line protocol is...
Displays the status of the line protocol on the specified tunnel.
Description
Description of the specified interface.
Internet address is...
IP address and subnet mask of the specified interface.
Source
IP address of the tunnel’s source.
Destination
IP address of the tunnel’s source.
Tunnel mtu is set to...
Size of the specified tunnel’s MTU.
Tunnel is an...
Description of the specified tunnel.
Tunnel is...
Whether or not the specified tunnel is trusted.
Inter tunnel flooding
is...
Status of inter tunnel flooding on the specified tunnel.
Tunnel keepalive is...
Status of tunnel keepalive on the specified tunnel.