Reference Guide

108 | ap-name Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description Default
mgmt-profile
profile" on page 1508.
enet0-profile
Configures the duplex and speed of the Ethernet 0 interface on the
AP. See "ap enet-link-profile" on page 119.
“default”
enet1-profile
Configures the duplex and speed of the Ethernet 1 interface on the
AP. See "ap enet-link-profile" on page 119.
“default”
event-thresholds-profile
Configures Received Signal Strength Indication (RSSI) metrics. See
"rf event-thresholds-profile" on page 535.
“default”
exclude-mesh-cluster-
profile-ap
Excludes the specified mesh cluster profile from this AP.
The Secure Enterprise Mesh license must be installed.
—
exclude-virtual-ap
Excludes the specified virtual AP profiles from this AP.
ids-profile
Configures Dell’s Intrusion Detection System (IDS). See "ids profile"
on page 295.
“default”
mesh-cluster-profile
Configures the mesh cluster profile for the AP (mesh node). There is
a “default” mesh cluster profile; however, it is not applied until you
provision the mesh node. See "ap mesh-cluster-profile" on page
127.
The Secure Enterprise Mesh license must be installed.
“default”
priority
Configures the priority of the mesh cluster profile. If more than two
mesh cluster profiles are configured, mesh points use this number to
identify primary and backup profile(s).
The supported range of values is 1-16. The lower the number, the
higher the priority.
1
mesh-radio-profile
Configures the 802.11g and 802.11a radio settings for the AP (mesh
node). See "ap mesh-ht-ssid-profile" on page 129.
The Secure Enterprise Mesh license must be installed.
“default”
no
Negates any configured parameter. —
regulatory-domain-profile
Configures the country code and valid channels. See "ap regulatory-
domain-profile" on page 146.
“default”
rf-optimization
-profile
Configures load balancing and coverage hole and interference
detection. See "rf optimization-profile" on page 540.
“default”
snmp-profile
Configures SNMP-related parameters. See "ap snmp-profile
(deprecated)" on page 150.
“default”
virtual-ap
One or more profiles, each of which configures a specified WLAN.
See "wlan virtual-ap" on page 1512.
“default”
voip-cac-profile
Configures voice over IP (VoIP) call admission control (CAC) options.
See "wlan voip-cac-profile" on page 1520.
This parameter requires the PEFNG license.
“default”
Usage Guidelines
Profiles that are applied to an AP group can be overridden on a per-AP name basis, and virtual APs can be added or
excluded on a per-AP name basis. If a particular profile is overridden for an AP, all parameters from the overriding