Reference Guide

1170 | show ntp servers Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
The following example shows the ntp servers configuration. The NTP server IP address, key ID and iburst status are
shown when the ntp servers brief command is used.
(host) (config) #show ntp servers brief
server 1.1.1.1 key 1234
server 10.1.1.245 iburst key 12345
Related Commands
To configure an NTP server, use the command ntp server.
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 6.1 The key-id parameter output displays when the ntp servers brief command is used.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on local and master
controllers