Reference Guide

1174 | show packet-capture Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
show packet-capture
show packet-capture
Description
Displays packet capture status on the controller.
Syntax
No parameters.
Example
The output of this command shows the packet capture configuration details.
(host) # show packet-capture
Current Active Packet Capture Actions(current switch)
=====================================================
Packet filtering TCP with 1 port(s) enabled:
2
Packet filtering UDP with 1 port(s) enabled:
5
Packet filtering for internal messaging opcodes disabled.
Packet filtering for all other packets enabled.
Packet Capture Defaults(across switches and reboots if saved)
============================================================
Packet filtering TCP with 1 port(s) enabled:
2
Packet filtering UDP with 1 port(s) enabled:
5
Packet filtering for internal messaging opcodes disabled.
Packet filtering for all other packets enabled.
Command History
This command was available in ArubaOS 3.3.2
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config or Enable mode on master or local
controllers