Reference Guide

124 | ap lldp profile Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
ap lldp profile
ap lldp profile <profile>
clone <profile>
dot1-tlvs port-vlan|vlan-name
dot3-tlvs link-aggregation|mac|mfs|power
lldp-med-network-policy-profile <profile>
lldp-med-tlvs capabilities|inventory|network-policy
no ...
optional-tlvs capabilities|management-address|port-description|system-description|system-
name
receive
transmit
transmit-hold <transmit-hold>
transmit-interval <transmit-interval>
Description
Define an LLDP profile that specifies the type-length-value (TLV) elements to be sent in LLDP PDUs.
Syntax
Parameter Description
clone <profile>
Make a copy of an existing LLDP profile.
dot1-tlvs
Specify which of the following 802.1 TLVs the AP will send in LLDP PDUs.
By default, the AP will send all 802.1 TLVs.
port-vlan
Transmit the LLDP 802.1 port VLAN TLV. If the native VLAN is configured
on the port, the port-vlan TLV will send that value, otherwise it will send
a value of “0”.
vlan-name
Transmit the LLDP 802.1 VLAN name TLV. The AP sends a value of
"Unknown" for VLAN 0, or "VLAN <number>" for non-zero VLAN numbers.
dot3-tlvs
Specify which of the following 802.3 TLVs the AP will send in LLDP PDUs.
By default, the AP will send all 802.3 TLVs.
link-aggregation
Transmit the 802.3 link aggregation TLV to indicate that link aggregation
is not supported.
mac
Transmit the 802.3 MAC/PHY Configuration/Status TLV to indicate the AP
interface’s duplex and bit rate capacity and current duplex and bit rate
settings.
mfs
Transmit the 802.3 Maximum Frame Size (MFS) TLV to show the AP’s
maximum frame size capability.
power
Transmit the 802.3 Power Via media dependent interface (MDI) TLV to
show the power support capabilities of the AP interface.
NOTE: This parameter is supported by the W-IAP3WNP and W-AP130
series only.
lldp-med-network-policy-profile
<profile>
Specify the LLDP MED Network Policy profile to be associated with this
LLDP profile.