Reference Guide

show vlan status
show vlan status <id>
Description
This command shows the current status of all VLANs on the controller.
Syntax
No parameters.
Usage Guidelines
Issue this command to show the status of VLANs on the controller. The VLANID column displays the VLAN ID
name or number. The IP Address column provides the VLAN’s IP address. The Adminstate column indicates if the
VLAN is enabled or disabled. The Operstate column indicates if the VLAN is currently up and running. The
PortCount column shows how many ports are associated with the VLAN. The Nat Inside column displays whether
source Nat is enabled for the VLAN interface. If Nat is enabled, all the traffic passing through this VLAN interface is
the source natted to the outgoing interface’s IP address.
(host) #show vlan status
Vlan Status
-----------
VlanId IPAddress Adminstate Operstate PortCount Nat Inside
------ --------- ---------- --------- --------- ----------
1 10.168.254.221/255.255.255.252 Enabled Up 5 Disabled
2 unassigned/unassigned Enabled Down 2 Disabled
4 unassigned/unassigned Enabled Down 1 Disabled
25 unassigned/unassigned Enabled Down 1 Disabled
212 10.168.212.2/255.255.255.0 Enabled Down 2 Disabled
213 10.168.213.2/255.255.255.0 Enabled Down 2 Disabled
1170 10.3.132.14/255.255.255.0 Enabled Up 2 Disabled
Related Commands
(host) (config) #vlan
(host) (config) #vlan-name
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or config mode on master or local
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show vlan status | 1311