Reference Guide

Parameter Description
l approved-ready-for-cert: AP is valid, but is waiting to receive a certificate.
l certified-factory-cert: AP has an approved factory-installed certificate
l certified-controller-cert: AP has an approved certificate from the controller.
l certified-hold-factory-cert: An AP is put in this state when the controller thinks the AP
has been certified with a factory certificate yet the AP requests to be certified again.
Since this is not a normal condition, the AP will not be reapproved as a secure AP until
a network administrator manually changes the status of the AP to verify that it is not
compromised.
l certified-hold-controller-cert: An AP is put in this state when the controller thinks the
AP has been certified with a controller certificate yet the AP requests to be certified
again. Since this is not a normal condition, the AP will not be reapproved as a secure
AP until a network administrator manually changes the status of the AP to verify that it
is not compromised.
Cert-Type
Type of certificate used by the AP.
l switch-cert: AP received a certificate from the controller
l factory-cert: AP has a factory-installed certificate
Description
If you included an optional description when you added the AP to the campus AP whitelist,
that description will appear here.
Revoke Text
If you included an optional revoke description when you manually revoked the AP, that
description will appear here.
Secondary Key
For internal use only.
Last Updated
Date and time that the AP record was last updated in the database.
Related Commands
Command Description Mode
whitelist-db cpsec add mac-address <mac-
address>
Configure the campus AP whitelist for the control plane
security feature.
Config mode
Command History
This command was introduced in ArubaOS 5.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system. Enable mode on master or local controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show whitelist-db cpsec | 1347