Reference Guide

Parameter Description
Advertise 802.11K
Capability
Shows if the profile has enabled or disabled the 802.11K feature.
Forcefully disassociate
on-hook voice clients
If enabled, the AP may forcefully disassociate clients that reach the maximum CAC peak
capacity or call handoff reservation.
Measurement Mode for
Beacon Reports
Shows the profile’s beacon measurement mode:
l active: In this mode, the client sends a probe request to the broadcast destination
address on all supported channels, sets a measurement duration timer, and, at the
end of the measurement duration, compiles all received beacons or probe response
with the requested SSID and BSSID into a measurement report.
l beacon-table: In this mode, the client measures beacons and returns a report with
stored beacon information for any supported channel with the requested SSID and
BSSID. The client does not perform any additional measurements. This is the default
beacon measurement mode.
l passive: In this mode, the client sets a measurement duration timer, and, at the end
of the measurement duration, compiles all received beacons or probe response with
the requested SSID and BSSID into a measurement report.
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on master or local controllers.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show wlan dot11k-profile | 1359