Reference Guide

Parameter Description Range Default
up again, the value is restored to the previous
priority level.
The combined priority and tracking vales cannot
exceed 255.
If the priority value exceeds 255, the controller
displays an error message.
tracking master-up-time
duration
Monitors how long the controller has been
master for the VRRP instance.
0-1440
minutes
—
tracking master-up-time
add
Instructs the controller to add the specified value
to the existing priority level.
The combined priority and tracking values cannot
exceed 255.
If the priority value exceeds 255, the controller
displays an error message similar to the
following:
Error: Vrrp 30 priority + tracking value exceeds
255
0-255 —
tracking vlan
Configures VRRP tracking based on VLAN state
transitions.
You can track a combined maximum of 16 VLAN
and Layer-2 interfaces.
— —
sub
Decreases the priority of the VRRP instance by
the specified amount. When the VLAN comes up
again, the value is restored to the previous
priority level.
The combined priority and tracking values cannot
exceed 255.
If the priority value exceeds 255, the controller
displays an error message.
0-255 —
vrrp-master-
state
Specifies the VRID to use for tracking the state of
the VRRP master controller.
1-255 —
vrrp-master-
state add
Instructs the controller to add the specified value
to the existing priority level.
The combined priority and tracking values cannot
exceed 255.
If the priority value exceeds 255, the controller
displays an error message similar to the
following:
Error: Vrrp 30 priority + tracking value exceeds
255
0-255 —
vlan
Specifies the VLAN ID of the VLAN on which
VRRP will run.
1-4094 —
Usage Guidelines
Use this command to set parameters for VRRP on the controller. The default VRRP parameters can be left for most
implementations.
You can use a combination of numbers, letters, and characters to create the authentication password and the VRRP
description. To include a space in the password or description, enter quotation marks around the string. For example,
to create the password Floor 1, enter “Floor 1” at the prompt.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide vrrp | 1465