Reference Guide

1492 | wlan handover-trigger-profile Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
wlan handover-trigger-profile
wlan handover-trigger-profile <profile-name>
clone <source>
handover-threshold <handover-threshold>
handover-trigger
no
Description
Configure a handover trigger profile to ensure QoS for voice calls.
Syntax
Parameter Description Range Default
<profile-name>
Name of this instance of the profile. The name must be 1-63
characters.
— "default"
clone <source>
Creates a copy of the Handover Trigger Profile specified as the
<source>. <source> is the name of an existing Handover Trigger
Profile from which parameter values are copied.
— —
handover-
threshold
<handover-
threshold>
If the best signal strength (-dbm) of a WiFi signal received by a
voice client from all the APs is equal to or lesser than this
threshold value, the handover trigger feature initiates the
handover process.. Threshold values can be specified in the
range 20 to 70.
20 – 70
-dBM
50 -dBM
handover-trigger
Issue this command to enable the handover trigger feature. If
enabled, the controller will initiate the handover of a voice client
(for example: dual mode handsets) roaming at the edge of Wi-Fi
coverage to an alternate carrier or connection. The handover
trigger is initiated if the Wi-Fi signal strength reported by the voice
client (received from all APs) is equal to or less than the threshold
value.
You must enable dot11k before using this command.
— Enabled
no
Negates any configured parameter. — —
Usage Guidelines
The handover-trigger profile is a part of the 802.11K profile. It is used to configure the parameters for the “Wi-Fi
Edge Detection and Handover of Voice Clients” feature. It is mandatory to enable the 802.11K feature before
enabling the“Wi-Fi Edge Detection and Handover of Voice Clients” feature.
Example
The following command enables the handover trigger feature and sets the handover threshold at -20dbm.
(host) (config) #wlan handover-trigger-profile default
(host) (Handover Trigger Profile "default") #handover-trigger
(host) (Handover Trigger Profile "default") #handover-threshold 20
Command History
This command was introduced in ArubaOS 6.2.