Reference Guide

156 | ap system-profile Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description Range Default
aeroscout-rtls-
server
Enables the AP to send RFID tag information to an
AeroScout real-time asset location (RTLS) server.
— —
am-scan-rf-band Scanning band for multiple RF radios a, g, all all
a Set the scanning band to 802.11a only — all
g Set the scanning band to 802.11g only — all
all Set the scanning band to apply to all bands — all
ip-addr IP address of the AeroScout server to which location
reports are sent.
— —
port Port number on the AeroScout server to which location
reports are sent.
— —
bkup-lms-ip In multi-controller networks, specifies the IP address of
a backup to the IP address specified with the lms-ip
parameter.
— —
bkup-lms-ipv6 In multi-controller ipv6 networks, specifies the IPv6
address of a backup to the IPv6 address specified with
the lms-ipv6 parameter.
— —
bootstrap-
threshold
Number of consecutive missed heartbeats on a GRE
tunnel (heartbeats are sent once per second on each
tunnel) before an AP rebootstraps. On the controller, the
GRE tunnel timeout is 1.5 x bootstrap-threshold; the
tunnel is torn down after this number of seconds of
inactivity on the tunnel.
1-65535 8
clone Name of an existing AP system profile from which
parameter values are copied.
— —
dns-domain Name of domain that is resolved by corporate DNS
servers. Use this parameter when configuring split
tunnel.
— —
double-encrypt This parameter applies only to remote APs. Use double
encryption for traffic to and from a wireless client that
is connected to a tunneled SSID.
When enabled, all traffic is re-encrypted in the IPsec
tunnel. When disabled, the wireless frame is only
encapsulated inside the IPsec tunnel.
All other types of data traffic between the controller and
the AP (wired traffic and traffic from a split-tunneled
SSID) are always encrypted in the IPsec tunnel.
— disabled
dump-server (For debugging purposes.) Specifies the server to
receive a core dump generated when an AP process
crashes.
— —
heartbeat-dscp Define the DSCP value of AP heartbeats.
Use this feature to prioritize AP heartbeats and prevent
the AP from losing connectivity with the controller over
high-latency or
low-bandwidth WAN connections.
0-63 0