Reference Guide

Parameter Description Range Default
in the system.
clone
Copy data from another IDS Denial Of
Service Profile.
— —
cts-rate-quiet-time
Time to wait, in seconds, after detecting a
CTS rate anomaly after which the check can
be resumed.
60-360000
seconds
900
seconds
cts-rate-threshold
Number of CTS control packets over the time
interval that constitutes an anomaly.
0-100000 5000
cts-rate-time-interval
Time interval, in seconds, over which the
packet count should be checked.
1-120
seconds
5 seconds
deauth-rate-thresholds
Rate threshold for deauthenticate frames. — —
detect-ap-flood
Enables detection of flooding with fake AP
beacons to confuse legitimate users and to
increase the amount of processing needed
on client operating systems.
true
false
false
detect-block-ack-dos
Enable/disable detection of attempts to reset
traffic receive windows using forged Block
ACK Add messages.
true
false
true
detect-chopchop-attack
Enable/disable detection of ChopChop
attack.
true
false
false
detect-client-flood
Enable/disable detection of client flood
attack.
true
false
disable
detect-cts-rate-anomaly
Enable/disable detection of CTS rate
anomaly.
true
false
disable
detect-disconnect-station
In a station disconnection attack, an attacker
spoofs the MAC address of either an active
client or an active AP. The attacker then
sends deauthenticate frames to the target
device, causing it to lose its active
association.
Use this command to enable the detection of
disconnect station attack.
true
false
enable
detect-eap-rate-anomaly
Enables Extensible Authentication Protocol
(EAP) handshake analysis to detect an
abnormal number of authentication
procedures on a channel and generate an
alarm when this condition is detected.
true
false
false
detect-fata-jack-attack
Enable/disable detection of FATA-Jack attack true
false
enable
detect-ht-40mhz-intolerance
Enables or disables detection of 802.11n 40
MHz intolerance setting, which controls
whether stations and APs advertising 40 MHz
intolerance will be reported.
true
false
false
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide ids dos-profile | 283