Reference Guide

486 | provision-ap Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
usb-passwd <usb-passwd>
usb-power-mode auto|enable|disable
usb-tty <usb-tty>
usb-tty-control <usb-tty-control>
usb-type <usb-type>
usb-user <usb-user>
Description
This command provisions or reprovisions an AP.
Syntax
Parameter Description Range
a-ant-bearing
Determines the horizontal coverage distance of the 802.11a (5GHz)
antenna from True North.
From a planning perspective, the horizontal coverage pattern does not
consider the elevation or vertical antenna pattern.
NOTE: This parameter is supported on outdoor APs only. If you use this
parameter to configure an indoor AP, an error message is displayed.
0-360 Dec-
imal
Degrees
a-ant-gain
Antenna gain for 802.11a (5GHz) antenna. —
a-ant-tilt-angle
Directs the angle of the 802.11a (5GHz) antenna for optimum coverage.
Use a - (negative) value for downtilt and a + (positive) value for uptilt.
NOTE: This parameter is supported on outdoor APs only. If you use this
parameter to configure an indoor AP, an error message is displayed.
-90 to +90
Decimal
Degrees
a-antenna
Antenna use for 5 GHz (802.11a) frequency band.
l 1: Use antenna 1
l 2: Use antenna 2
l both: Use both antennas (default)
1, 2, both
(default)
altitude
Altitude, in meters, of the AP.
NOTE: This parameter is supported on outdoor APs only. If you use this
parameter to configure an indoor AP, an error message is displayed.
—
ap-group
Name of the AP group to which the AP belongs.
—
ap-name
Name of the AP to be provisioned.
—
apdot1x-passwd
Password of the AP to authenticate to 802.1X using PEAP.
—
apdot1x-username
Username of the AP to authenticate to 802.1X using PEAP.
—
cellular_nw_preference
g-only|4g-only|
advanced|auto
The Cellular Network Preference setting introduced in ArubaOS 6.2.1.0
allows you to select how the modem should operate.
l auto (default): In this mode, modem firmware will control the cellular
network service selection; so the cellular network service failover
and fallback is not interrupted by the remote AP (RAP).
l 3g_only: Locks the modem to operate only in 3G.
l 4g_only: Locks the modem to operate only in 4G.
l advanced: The RAP controls the cellular network service selection
based on an Received Signal Strength Indication (RSSI) threshold-
—