Reference Guide

488 | provision-ap Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description Range
ip6addr
Static IPv6 address of the AP. —
ip6prefix
The prefix of static IPv6 address of the AP. —
ipaddr
Static IP address for the AP. —
latitude
Latitude coordinates of the AP. Use the format: Degrees, Minutes,
Seconds (DMS). For example: 37 22 00 N
—
link-priority-cellular
<link-priority-cellular>
Set the priority of the cellular uplink. By default, the cellular uplink is a
lower priority than the wired uplink; making the wired link the primary
link and the cellular link the secondary or backup link.
Configuring the cellular link with a higher priority than your wired link
priority will set your cellular link as the primary controller link.
—
link-priority-ethernet
<link-priority-ethernet>
Set the priority of the wired uplink. Each uplink type has an associated
priority; wired ports having the highest priority by default.
—
longitude
Longitude coordinates of the AP. Use the DMS format.
For example: 122 02 00 W
—
master
Name or IP address of the master controller. —
mesh-role
Configure the AP to operate as a mesh node. You assign one of three
roles: mesh portal, mesh point or remote mesh point. If you select
“none,” the AP operates as a thin AP.
—
mesh-sae
Enable or disable Simultaneous Authentication of Equals (SAE) on a
mesh network. This option offers enhanced security over the default
wpa2-psk-aes mesh security setting, and provides secure, attack-
resistant authentication using a pre-shared key. SAE supports
simultaneous initiation of a key exchange, allowing either party to
initiate an exchange or both parties to initiate a key exchange
simultaneously
To use the SAE feature, you must enable this parameter on all mesh
nodes (points and portals) in the network, to prevent mesh link
connectivity issues.
NOTE: This is a Beta feature only. This parameter should be kept
“disabled” for this release.
—
netmask
Netmask for the IP address. —
no
Negates any configured parameter. —
pap-passwd
Password Authentication Protocol (PAP) password for the AP.
You can use special characters in the PAP password. Following are the
restrictions:
l You cannot use double-byte characters
l You cannot use a tilde (~)
l You cannot use a tick (‘)
l If you use quotes (single or double), you must use the backslash (\)
before and after the password
—
pap-user
PAP username for the AP.
—
pppoe-chap-secret
PPPoE CHAP secret key for the AP.
—