Reference Guide

492 | provision-ap Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.2 Introduced support for the mesh parameters, additional antenna parameters, and AP
location parameters.
ArubaOS 3.4 Introduced support for the following parameters:
l installation
l mesh-sae
l set-ikepsk-by-addr
l usb-dev
l usb-dial
l usb-init
l usb-passwd
l usb-tty
l usb-type
l usb-user
l link-priority-cellular
l link-priority-ethernet
ArubaOS 5.0 The mesh-sae parameter no longer has the sae-default option. Use the sae-disable
option to return this parameter to its default disabled setting.
ArubaOS 6.0 The uplink-vlan parameter was introduced.
ArubaOS 6.1 The following new parameters were introduced for provisioning IPv6 APs:
l dns-server-ip6
l ip6addr
l ip6prefix
l gateway6
ArubaOS 6.2 The following new parameters were introduced for provisioning APs in single-chain
mode:
l sch-mode-radio-0
l sch-mode-radio-1
The following new parameters were introduced for provisioning APs for 802.1X
authentication:
l apdot1x-passwd
l apdot1x-username
The following new parameters were introduced for provisioning Remote APs using USB
modems:
l usb-modeswitch
l 4g-usb-type
ArubaOS 6.2.1.0 The
cellular_nw_preference
parameter was introduced for provisioning multi-mode
modems, and the
4g-usb-type
parameter was deprecated. Specify a 2/3G or 4G modem
type using the
usb-type
parameter.
Command Information
Platforms Licensing Command Mode
All platforms, except for the
parameters noted in the Syntax table.
Base operating system, except for
the parameters noted in the Syntax
table.
Config mode on master controllers