Reference Guide

502 | remote-node-masterip Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
remote-node-masterip
remote-node-masterip <masterip>
ipsec key <pre-shared key>
ipsec-factory-cert
Description
This command configures the IP address and preshared key or factory-installed certificate for the Remote-Node
Master on a local Remote Node.
Syntax
Parameter Description
<masterip>
IP address of the master Remote Node.
ipsec <key>
Secure communication between a Remote-Node and Remote-Node master by defining a preshared
key, which must be between 6-64 characters.
ipsec-factory-cert
Secure communication between a Remote-Node and Remote-Node master by identifying a factory-
installed certificate on the Remote-Node Master.
Usage Guidelines
Use this command on a local Remote Node to configure the IP address and preshared key for communication with
the master Remote Node. On the master controller, use the
remote-node-localip command to configure the IP address and preshared key for a local Remote Node.
NOTE: Changing the IP address of the master on a local Remote Node requires a reboot of the local Remote Controller.
Example
The following command configures the Remote-Node Master on a local Remote Node:
(host) (config) #remote-node-masterip 172.16.0.254 ipsec rhyopevs
Command History
Release Modification
ArubaOS 3.0 Command introduced.
ArubaOS 6.1 The ipsec-factory-cert parameter was introduced to allow certificate-based
authentication of Remote-Node Masters.
Command Information
Platform License Command Mode
Available on all platforms Available in the base operating system Config mode on local Remote Nodes.