Reference Guide

530 | rf dot11g-radio-profile Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description Range Default
signal strength.
If the value is set to zero, the feature will
automatically determine an appropriate threshold.
disable-arm-wids-function
Disables Adaptive Radio Management (ARM) and
Wireless IDS functions. These can be disabled if a
small increase in packet processing performance
is desired. If a radio is configured to operate in Air
Monitor mode, then these functions are always
enabled irrespective of this option. CAUTION: Use
carefully, since this effectively disables ARM and
WIDS
1-16 4
dot11b-protection
Enable or disable protection for 802.11b clients.
This parameter is enabled by default. Disabling
this feature may improve performance if there are
no 802.11b clients on the WLAN.
WARNING: Disabling protection violates the 802.11
standard and may cause interoperability issues. If
this feature is disabled on a WLAN with 802.11b
clients, the 802.11b clients will not detect an
802.11g client talking and can potentially transmit
at the same time, thus garbling both frames.
— enabled
dot11h
Enable advertisement of 802.11d (Country
Information) and 802.11h (TPC or Transmit Power
Control) capabilities This parameter is disabled by
default.
— disabled
high-throughput-enable
Enables high-throughput (802.11n) features on a
radio using the 2.4 GHz frequency band.
— enabled
ht-radio-profile
Name of high-throughput radio profile to use for
configuring high-throughput support on the 5 GHz
frequency band. See "rf ht-radio-profile" on page
538.
— “default-
a”
interference-immunity
Set a value for 802.11 Interference Immunity. The
default setting for this parameter is level 2. When
performance drops due to interference from non-
802.11 interferers (such as DECT or Bluetooth
devices), the level can be increased up to level 5
for improved performance. However, increasing
the level makes the AP slightly “deaf” to its
surroundings, causing the AP to lose a small
amount of range.
The levels for this parameter are:
l Level-0: no ANI adaptation.
l Level-1: noise immunity only.
l Level-2: noise and spur immunity. This is the
default setting
l Level-3: level 2 and weak OFDM immunity.
l Level-4: level 3 and FIR immunity.
l Level-5: disable PHY reporting.
NOTE: Do not raise the noise immunity feature’s
default setting if the "channel-reuse-threshold" on
page 521 feature is also enabled. A level-3 to
level-5 Noise Immunity setting is not compatible
with the Channel Reuse feature.
Level-0 -
Level-5
Level-2