Reference Guide

6 | Introduction Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Command Parameter Description
mode-radio-1
0 or command to enable single-chain mode for the selected radio. AP
radios in single-chain mode will transmit and receive data using only
legacy rates and single-stream HT rates up to MCS 7. This setting is
disabled by default.
rf arm-profilerf arm-profile
Channel quality percentage below which ARM initiates a channel
change.
rf arm-profilerf arm-profile
If channel quality is below the specified channel quality threshold for this
wait time period, ARM initiates a channel change.
service
The dhcpv6 parameter is introduced. This command enables DHCPv6
service on the controller.
show ap debug counters
Added APcrash information.
show ap debug system-status
Added CPU usage statistics.
show ap remote debug mgmt-frames
Added deauthentication reason explanation to output table.
show datapath
Following parameters were added:
l network ingress
l internal dir
l error counters
l debug opcode
l trace-route
l ip-fragment
show ap debug system-status
Added parameters to display Control-Plane security, OSPF, SAPM, Sta-
tion Management low priority, syslog database, user database, and wrie-
less management statistics.
show mgmt-users
The Revocation Checkpoint (rcp)appears in the outpoint.
show storage
Information detailing attached USB storage devices now appear in the
output. This is applicable to the W-7200 series Series controllers only.
show user
The output now shows if IP address is from DHCP.
show vlan mapping
The Assignment Type appears in the output.
vlan-name <name> [pool|assignment
{even|hash}]
Sets the assignment type as even or hash.The Even assignment type is
based on an even distribution of VLAN pool assignments. The hash type
means that the VLAN assignment is based on the station MAC address.
wlan dot11k-profile
The following parameters were introduced:
l bcn-req-chan-11a
l bcn-req-chan-11bg
l ap-chan-rpt-11a
l ap-chan-rpt-11bg
l handover-trigger-profile
l rrm-ie-profile
l bcn-rpt-req-profile
l tsm-req-profile
The handover trigger threshold parameter was deprecated, as the hand-