Reference Guide

Port ACL Hits
-------------
ACL ACE New Hits Total Hits Index
--- --- -------- ---------- -----
5 22 0 14 238
The output of this command includes the following information:
Parameter Description
Role
Name of the role assigned by the ACL.
Policy
Name of the policy used by the ACL
Src
The traffic source, which can be one of the following:
l <alias> : Name of a user-defined alias for a network host, subnetwork, or range of
addresses.
l any: match any traffic.
l host: specify a single host IP address.
l network: specify the IP address and netmask.
l user: represents the IP address of the user.
Dst
The traffic destination, which can be one of the following:
l <alias> : Name of a user-defined alias for a network host, subnetwork, or range of
addresses.
l any: match any traffic.
l host: specify a single host IP address.
l network: specify the IP address and netmask.
l user: represents the IP address of the user.
Service
Network service, which can be one of the following:
l IP protocol number (0-255)
l name of a network service (use the show netservice command to see configured
services)
l any: match any traffic
l tcp: specify the TCP port number (0-65535)
l udp: specify the UDP port number (0-65535)
Action
Action if rule is applied, which can be one of the following:
l deny: reject packets
l dst-nat: perform destination NAT on packets
l dual-nat: perform both source and destination NAT on packets
l permit: forward packets
l redirect: specify the location to which packets are redirected
l src-nat: perform source NAT on packets
Dest/Opcode
The datapath destination ID.
New Hits
Number of ACL hits that occurred since this command was last issued.
Total Hits
Total number of ACL hits recorded since the controller last reset.
Index
Index number of the ACL.
ACL
ACL number
ACE
ACE number
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show acl hits | 651