Reference Guide

show adp config
show adp config
Description
Show Aruba Discovery Protocol (ADP) configuration settings.
Syntax
No parameters.
Example
The following example shows that the controller has all default settings for ADP.
(host) #show adp config
ADP Configuration
-----------------
key value
--- -----
discovery enable
igmp-join enable
igmp-vlan 0
The output of this command includes the following parameters:
Parameter Description
discovery
Dell APs send out periodic multicast and broadcast queries to locate the master
controller. If the APs are in the same broadcast domain as the master controller and
ADP is enabled on the controller, the controller automatically responds to the APs’
queries with its IP address.
This command shows whether ADP is enabled or disabled on the controller.
igmp-join
Shows whether the controller has enabled or disabled the sending of Internet Group
Management Protocol (IGMP) join requests.
igmp-vlan
ID of the VLAN to which IGMP reports are sent. If this value is set to 0, the controller will
use the default route VLAN used.
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show adp config | 653