Reference Guide

668 | show ap arm history Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
The output of this command includes the following information:
Parameter Description
Reason
This column displays one of the following code to indicate why the channel or power
change was made.
l I: Interference
l R: Radar detected
l N: Noise exceeded
l E: Error threshold exceeded
l INV: Invalid Channel
l G: Rogue AP Containment
l M: Empty Channel
l P+: Increase Power
l P-: Decrease Power
l OFF: Turn off Radio
l ON: Turn on Radio
The Reason key appears at the bottom of the ARM History table.
Old Channel
Channel number used by the AP interface before the ARM change.
New Channel
Channel number used by the AP interface after the ARM change.
Old Power
Power level of the AP interface before the ARM change.
New Power
Power level of the AP interface after the ARM change.
Last Change
Time elapsed since the change, in the format days:hours:minutes:seconds .
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master or local
controllers