Reference Guide

WIF Scan Time
-------------
channel last-scan-channel current-scan-channel last-dos-channel
------- ----------------- -------------------- ----------------
48 56/50655 56 0
The output of this command includes the following parameters:
Parameter Description
channel
A radio channel on the specified AP.
Assign-time
The amount of time that an AP has been on a channel.
scans-attempted
The number of times an AP has attempted to scan another channel
scans-rejected
The number of times an AP attempted to scan a channel, but was unable to scan because
the scan was halted by the power save, VoIP aware or load aware ARM features.
dos-scans
The number of times an AP enabled with the rogue aware scanning feature had to contain a
rogue device on a channel.
flags
The flags column displays additional relevant information about the channel. The flags key
appears at the bottom of the Channel Scan Time table.
timer tick
Timer tick at which the last scan was attempted.
last-scan-channel
The last channel scanned by the AP
current-scan-channel
The AP’s current channel.
last-dos-channel
The last channel that had to be contained because a rogue device was detected on that
channel.
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap arm scan-times | 673