Reference Guide

694 | show ap config Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description
Keepalive Interval
Time, in seconds, between keepalive messages from the AP
Dump Server
(For debugging purposes.) Displays the server to receive the
core dump generated if an AP process crashes.
Telnet
Reports whether telnet access the AP is enabled or
disabled.
SNMP sysContact
SNMP system contact information.
AeroScout RTLS Server
Displays whether or not the AP will send RFID tag
information to an AeroScout real-time asset location (RTLS)
server.
RTLS Server configuration
Displays whether or not the AP will send RFID tag
information to an RTLS server.
Remote-AP DHCP Server VLAN
Shows the VLAN ID of the remote-AP DHCP server used
when controller is unreachable.
Remote-AP DHCP Server Id
Shows the IP Address of the DHCP DNS Server.
Remote-AP DHCP Default Router
Shows the IP Address of the DHCP Default Router.
Remote-AP DHCP Pool Start
Shows the IP Address used as start of DHCP Pool.
Remote-AP DHCP Pool End
Shows the IP Address used as end of DHCP Pool.
Remote-AP DHCP Pool Netmask
Shows the netmask of DHCP Pool.
Remote-AP DHCP Lease Time
Shows the length of leases, in days (0 means infinite).
Remote-AP uplink total bandwidth
This is the total reserved uplink bandwidth (in Kilobits per
second)
Remote-AP bw reservation
Session ACLs with uplink bandwidth reservation in kilobits
per second. You can specify up to three session ACLs to
reserve uplink bandwidth.
Heartbeat DSCP
DSCP value of AP heartbeats (0-63).
Session ACL
Shows the access control list (ACL) applied on the uplink of
a remote AP.
Maintenance Mode
Shows if Maintenance mode is enabled or disabled. If
enabled, APs stop flooding unnecessary traps and syslog
messages to network management systems or network
operations centers when deploying, maintaining, or
upgrading the network. The controller still generates debug
syslog messages if debug logging is enabled.
Remote-AP Local Network Access
Enable or disable local network access across VLANs in a
Remote-AP.
Radio enable
Shows if the AP’s radio is enabled or disabled.
Mode
Shows the operating modes for the AP.