Reference Guide

Parameter Description
MPDU Aggregation
Shows if the AP has enabled or disabled MAC protocol data
unit (MDPU) aggregation.
Max transmitted A-MPDU size
Shows the maximum size, in bytes, of an A-MPDU that can
be sent on the AP’s high-throughput SSID.
Max received A-MPDU size
Shows the maximum size, in bytes, of an Aggregated-MAC
Packet Data Unit (A-MPDU) that can be received on the
AP’s high-throughput SSID.
Min MPDU start spacing
Displays the minimum time between the start of adjacent
MDPUs within an aggregate MDPU, in microseconds.
Supported MCS set
Comma-separated list of Modulation Coding Scheme (MCS)
values or ranges of values to be supported on this high-
throughput SSID.
Short guard interval in 20 MHz mode
Shows if the AP has enabled or disabled use of short guard
interval in 20 MHz mode of operation.
Short guard interval in 40 MHz mode
Shows if the AP has enabled or disabled use of short guard
interval in 40 MHz mode of operation.
Maximum number of spatial streams usable
for STBC transmission
Controls the maximum number of spatial streams usable for
STBC transmission. 0 disables STBC transmission, 1 uses
STBC for MCS 0-7. Higher MCS values are not supported.
(Supported on the W-AP90, W-AP130 series, W-AP175
series, W-AP68 and W-AP105 only. The configured value
will be adjusted based on AP capabilities.)
Minimum number of spatial streams usable
for STBC transmission
Controls the maximum number of spatial streams usable for
STBC reception. 0 disables STBC reception, 1 uses STBC
for MCS 0-7. Higher MCS values are not supported.
(Supported on the W-AP90, W-AP130 series, W-AP175
series, W-AP68 and W-AP105 only. The configured value
will be adjusted based on AP capabilities.)
Legacy stations
Shows if the AP has enabled or disabled the legacy stations
option, which controls whether or not legacy (non-HT)
stations are allowed to associate with the AP’s SSID. By
default, legacy stations are allowed to associate.
NOTE: This setting has no effect on a BSS in which HT
support is not available.
Allow weak encryption
Shows if the AP has enabled or disabled the weak
encryption option.
The use of TKIP or WEP for unicast traffic forces the use of
legacy transmissions rates. Disabling this mode prevents
the association of stations using TKIP or WEP for unicast
traffic. This mode is disabled by default.
Virtual AP enable
Wireless LAN profiles configure WLANs in the form of
virtual AP profiles. This parameter shows if the AP has
enabled or disabled virtual APs.
Allowed band
Shows the band(s) on which to use the virtual AP:
l a—802.11a band only (5 GHz)
l g—802.11b/g band only (2.4 GHz)
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap config | 703