Reference Guide

Parameter Description
channel 2. This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR
Signal-to-noise ratio for the last received ACK packet.
Last ACK SNR CTL0
Signal-to-noise ratio for the last received ACK packet on the primary (control) channel 0.
This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR CTL1
Signal-to-noise ratio for the last received ACK packet on the primary (control) channel 1.
This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR CTL2
Signal-to-noise ratio for the last received ACK packet on the primary (control) channel 2.
This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR EXT0
Signal-to-noise ratio for the last received ACK packet on the secondary (extension) channel
0. This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR EXT1
Signal-to-noise ratio for the last received ACK packet on the secondary (extension) channel
1. This parameter is only displayed for APs operating in 40 Mhz mode.
Frames Received
Number of frames received.
Rx Data Frames
Number of data frames received.
Null Data Frames
Number of null data frames received.
Rx Mgmt Frames
Number of management frames received.
PS Poll Frames
Number of power save poll frames received.
Rx <n> Mbps
Number of frames received at <n> Mbps, where <n> is a value between 6 and 300.
Tx WMM
Number of Wifi Multimedia (WMM) packets transmitted for the following access
categories. If the AP has not transmitted packets in a category type, this data row will not
appear in the output of the command.
Tx WMM [BE]: Best Effort
Tx WMM [BK]: Background
Tx WMM [VO]: VoIP
Tx WMM [VI]: Video
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap debug client-stats | 725