Reference Guide

Column Description
NOTE: This parameter is supported on outdoor APs only. The horizontal
coverage pattern does not consider the elevation or vertical antenna pattern.
Antenna tilt angle for
802.11a
The angle of the 802.11a (5GHz) antenna. This parameter can range from
between -90 degrees and 0 degrees for downtilt, and between +90 degrees and
0 degrees for uptilt.
Antenna tilt angle for
802.11g
The angle of the 802.11g (2.4GHz) antenna. This parameter can range from
between -90 degrees and 0 degrees for downtilt, and between +90 degrees and
0 degrees for uptilt.
Mesh SAE
Shows if the AP has enabled or disabled Secure Attribute Exchange (SAE) on a
mesh network. This setting is disabled by default.
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.2 Introduced support for mesh parameters, additional antenna parameters, and AP
location parameters.
ArubaOS 3.4 Introduced support for the following parameters:
l installation
l mesh-sae
l set-ikepsk-by-addr
l usb-dev
l usb-dial
l usb-init
l usb-passwd
l usb-tty
l usb-type
l usb-user
ArubaOS 5.0 The mesh-sae parameter no longer displays the sae-default setting if the parameter is
disabled. Only the sae-disable option indicates that this parameter is currently in its
default disabled state.
ArubaOS 6.1 The parameter ip6-addr was added to show data for an IPv6 AP.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap details | 761