Reference Guide

764 | show ap ht-rates Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
show ap ht-rates
show ap ht-rates bssid <bssid>
Description
Show high-throughput rate information for a basic service set (BSS).
Syntax
Parameter Description
bssid <bssid>
Show data for a specific Basic Service Set Identifier (BSSID) on an AP. An AP’s BSSID is
usually the AP’s MAC address.
Examples
The output of this command shows high-throughput rates for each supported MCS value. These values are applicable
to high-throughput (802.11n-capable) APs only.
(host) #show ap ht-rates bssid 00:1a:1e:1e:5a:10
AP "AL12" Radio 0 BSSID 00:1a:1e:1e:5a:10 High-throughput Rates (Mbps)
----------------------------------------------------------------------
MCS Streams 20 MHz 40 MHz 40 MHz SGI
--- ------- ------ ------ ----------
0 1 6.5 13.5 15.0
1 1 13.0 27.0 30.0
2 1 19.5 40.5 45.0
3 1 26.0 54.0 60.0
4 1 39.0 81.0 90.0
5 1 52.0 108.0 120.0
6 1 58.5 121.5 135.0
7 1 65.0 135.0 150.0
8 2 13.0 27.0 30.0
9 2 26.0 54.0 60.0
10 2 39.0 81.0 90.0
11 2 52.0 108.0 120.0
12 2 78.0 162.0 180.0
13 2 104.0 216.0 240.0
14 2 117.0 243.0 270.0
15 2 130.0 270.0 300.0
The output of this command includes the following information:
Column Description
MCS
A Modulation Coding Scheme (MCS) values supported on this high-throughput SSID.
Streams
Number of spatial streams used by the MCS index value.
20 MHz
802.11n data rates for the MCS for 20 Mhz transmissions.
40 MHz
802.11n data rates for the MCS for 40 Mhz transmissions.
40 MHz SGI
802.11n data rates for the MCS for 40 Mhz transmissions using a short guard interval.