Reference Guide

792 | show ap mesh debug provisioned-clusters Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
show ap mesh debug provisioned-clusters
show ap mesh debug provisioned-clusters {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-
addr>}
Description
Show cluster profiles provisioned on a mesh portal or mesh point.
Syntax
Parameter Description
ap-name<ap-name>
Show data for a mesh node with a specific name.
bssid<bssid>
Show data for a mesh node with a specific Basic Service Set Identifier (BSSID). The Basic
Service Set Identifier (BSSID) is usually the AP’s MAC address.
ip-addr <ip-addr>
Show data for a mesh node with a specific IP address by entering an IP address in dotted-
decimal format.
Example
The output of the command below shows statistics for the AP’s mesh cluster profile and recovery cluster profile.
(host) #show ap mesh debug provisioned-clusters ap-name portal2
AP Portal Cluster Profile: mesh-cluster-profile
-------------------------------------------------
-------------------------
Parameter Value
--------- -----
Cluster Name sw-ad-GB32
RF Band a
Encryption opensystem
WPA Hexkey N/A
WPA Passphrase ********
AP "Portal" Cluster Profile: Recovery Cluster Profile
-----------------------------------------------------
Item Value
---- -----
Cluster Name Recovery-ZF-xAPl5z-g15VN
RF Band a
Encryption pa2-psk-aes
WPA Hexkey ********
WPA Passphrase N/A
The output of this command displays the following information for the AP’s mesh cluster profile and recovery cluster
profiles:
Column Description
Cluster Name Name of the mesh cluster using this profile
RF band The RF band in which the AP should operate: