Reference Guide

816 | show ap monitor debug Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Column Description
WMS on Master Indicates if the AP communicates to the wms process on a master or local controller.
enabled: Communicates with a master controller.
disabled: Communicates with a local controller only.
Stats Update Interval If the AP is collecting statistics, this value is the interval in seconds in which the AP sends
statistics to the WMS process on a controller.
Poll Interval Interval, in milliseconds, that the AP sends RSSI updates to the WMS process on a
controller.
Num Switches Number of controllers to which this AP has access. If the value is 1, the AP has access to a
master or a local controller. If the value is 2, the AP has access to a master and a local
controller.
Collect Stats If enabled, the AP will collect statistics to send the WMS process on its controller.
Bssid BSSID of the radio.
Type Indicates whether the controller type is master or local.
Status If up, the AP can reach the controller. If down, the AP cannot reach the controller.
Last-reg The time the AP last registered with the WMS process.
N-reg Number of times the AP has registered with the WMS process.
Last-update The last timer tick time the AP updated the WMS process.
Next-update Interval between the last update and the next scheduled update.
N-updates Number of updates sent to the WMS process.
Last-ack Number of timer ticks since the AP received an acknowledgement from the WMS process.
Type Type of RTLS server used by the AP, such as MMS or Aeroscout.
Server IP IP address of the RTLS server.
Port Port used by the RTLS server.
Frequency Rate, in seconds, at which RTLS messages are sent to the server.
Active Indicates if the server is active on the AP.
Command History
Version Modification
ArubaOS 3.0. Command introduced
ArubaOS 3.4. The tagged-pkts and vlan parameters were added to the Wired Interface table in the
output of the show ap monitor debug status command.