Reference Guide

show configuration
show configuration
Description
Show the saved configuration on the controller.
Syntax
No parameters.
Usage Guidelines
Issue this command to view the entire configuration saved on the controller, including all profiles, ACLs, and
interface settings.
Example
The example below shows part of the output for this command.
(host) # show configuration
version 6.2
enable secret "01270adf012bf3faf1a26a5987a53d78041a4287c0b62cb36a"
telnet cli
telnet soe
hostname "TechPubs650"
clock timezone PST -8
location "Building1.floor1"
controller config 7
ip NAT pool dynamic-srcnat 0.0.0.0 0.0.0.0
ip access-list eth validuserethacl
permit any
!
netservice svc-netbios-dgm udp 138
netservice svc-snmp-trap udp 162
Command History
This command was available in ArubaOS 1.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config or Enable mode on master or local
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show configuration | 923