Reference Guide

954 | show datapath Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description
ip-mcast
destination
group
Displays the data path IP multicast table statistics. These include source, group.
VLAN and destination.
ip-reassembly
Displays the contents of the IP Reassembly statistics tables.
ap-name <ap-name>
Name of the AP.
counters
IP reassembly counters.
ip-addr <ip-address>
IP address of the AP
ipv4
Displays the IPv4 contents of the IP Reassembly statistics table.
ipv6
Displays the IPv6 contents of the IP Reassembly statistics table.
ipv6-mcast
destination
group
Displays the data path IP multicast table statistics. These include source, group.
VLAN and destination.
lag table
Displays contents of the datapath link aggregation group (LAG) or port channel
table.
message-queue counters
Displays statistics of messages received by a CPU from other datapath CPUs (only
CPUs that receive messages and non-zero statistics are shown).
maintenance counters
Displays datapath maintenance statistics.
nat
Displays the contents of the datapath NAT entries table. It displays NAT pools as
configured in the datapath. Statistics include pool, SITP start, SIP end and DIP.
network ingress
Displays ingress queue counters.
ap-name <ap-name>
Name of AP.
counters
Nat counters.
ip-addr <ip-address>
IP address of the AP.
port
Displays the datapath port table information. This includes the port number, PVID,
Ingress ACL, Egress ACL, Session ACL, and the following flags:
l Q: trunk
l T: trusted
l B: blocked by the Spanning Tree protocol
l L: LSG
l M: tunneled node
l X: xSec
l Z: QinQ
link-event
Displays port link up and link down event counters.
monitor
Displays the monitor port configuration.
stats <slot/port>
Displays the physical port statistics.
status <slot/port>
Displays the physical port status.