Reference Guide

956 | show datapath Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description
services
Displays the datapath services table statistics including protocol, port and service.
session
Displays datapath session statistics
ap-name <ap-name>
Name of AP
counters
Displays counters statistics including current entries, high water mark, maximum
entries, total entries, allocation failures, duplicate entries, cross linked entries,
number of reverse entries and maximum link length.
ip-addr <ip-address>
IP address of the AP.
ipv6
Displays datapath IPv6 session entries and statistics including current entries, high
water mark, maximum entries, total entries, allocation failures, duplicate entries,
cross linked entries, number of reverse entries and maximum link length.
table
Displays all the IP flows of a wireless device or Dell AP. Statistics include table
entries including source IP, destination IP, protocol, SPort, DPort, Cntr, priority,
ToS, age, destination, TAge and flags.
station
Displays datapath station association table statistics.
counters
Display the current and high water mark amount of 802.11 associated wireless
devices on an Dellcontroller. Values output from this command represent the
water-marks since the last boot of the controller. This is the same value obtainable
from the Num Associations output from the show stm connectivity command.
mac <macaddr>
Hardware address, in hexadecimal format.
tcp
Displays contents of the tcp tunnel table. This command displays all tcp tunnels
that are terminated by the controller,
app <app>
Name of the application.
counters
Displays the tcp tunnel statistics.
tunnel
Displays the tcp tunnel table.
table
This command displays the Datapath Station Table Statistics detail.
Display all associated wireless devices on the Dellcontroller with their
corresponding AP BSSID and VLAN ID.
Displays the wireless device is associated with the correct encryption type (if the
device is associated to an AP BSSID that has encryption enabled and verifies
whether the Dellcontroller is having a problem in decrypting the wireless device’s
frames.
tunnel
Displays contents of the datapath tunnel table. This command displays all the
tunnels that are terminated by the controller, including Dell APs’ GRE tunnels. For
example, a GRE tunnel is created and terminated on the Dellcontroller for every
SSID/BSSID configured on the Dell AP.
counters
Tunnel counters.
ipv4
Displays the tcp tunnel table filtered on IPv4 entries.
ipv6
Displays the tcp tunnel table filtered on IPv6 entries.