Reference Guide

adp
adp discovery {disable|enable} igmp-join {disable|enable} igmp-vlan <vlan>
Description
This command configures the Aruba Discovery Protocol (ADP).
Syntax
Parameter Description Range Default
discovery
Enables or disables ADP on the controller. enabled/
disabled
enabled
igmp-join
Enables or disables sending of Internet Group
Management Protocol (IGMP) join requests from
the controllers.
enabled/
disabled
enabled
igmp-vlan
VLAN to which IGMP reports are sent. — 0 (default route
VLAN used)
Usage Guidelines
Dell APs send out periodic multicast and broadcast queries to locate the master controller. If the APs are in the
same broadcast domain as the master controller and ADP is enabled on the controller, the controller automatically
responds to the APs’ queries with its IP address. If the APs are not in the same broadcast domain as the master
controller, you need to enable multicast on the network. You also need to make sure that all routers are configured to
listen for IGMP join requests from the controller and can route the multicast packets. Use the show adp config
command to verify that ADP and IGMP join options are enabled on the controller.
Example
The following example enables ADP and the sending of IGMP join requests on the controller:
adp discovery enable igmp-join enable
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide adp | 99