Release Notes

AP State Running
Entry created 2008-10-23 20:04:53
Last activity 2008-10-28 08:07:48
Reboots 0
Bootstraps 1
Bootstrap Threshold 7Slot/Port 2/24
The output of this command includes the following information:
Column Description
AP IP Address
IP address of the AP
LMS IP Address
The IP address of the local management switch (LMS)—the Dell
controller which is responsible for terminating user traffic from the
APs, and processing and forwarding the traffic to the wired network.
Group
Name of the AP’s AP group.
Location Name
Location of the AP.
Status
Current status of the AP, either Up or Down.
Up time
Number of hours, minutes and seconds since the last controller
reboot or bootstrap, in the format hours:minutes:seconds.
Installation
AP Installation mode. The AP can be default (the factory set AP
installation type, indoor or outdoor.
AP Type
AP model
Serial #
Serial number for the AP
Wired MAC address
MAC address of the wired interface.
Radio 0 BSSID
Basic Service Set Identifier (BSSID) of the AP’s radio 0. This is
usually the radio’s MAC address.
Radio 1 BSSID
Basic Service Set Identifier (BSSID) of the AP’s radio 1. This is
usually the radio’s MAC address.
Enet 1 MAC address
MAC address of the AP’s Ethernet port.
Service Tag
Service tag of the AP.
AP State
Displays the AP’s current operational state.
Entry created
Timestamp showing the time the AP registered with the controller.
Last activity
Timestamp showing the last time the AP communicated with the
controller. An AP typically sends keepalive messages every minute.
Reboots
Number of times power to the AP cycled off and then on again.
Reboots also known as “hard” restarts.
Bootstraps
Number of times the AP restarted. Bootstraps are also known as
“soft” restarts.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show ap details | 1022