Release Notes

show ap mesh tech-support
show ap mesh tech-support ap-name <ap-name> <filename>
Description
Display all information for an AP, and save that information in a file on the controller
Syntax
Parameter Description
<ap-name>
Name of an AP for which you want to create a report
<filename>
Filename for the report created by this command. The file can only be saved in
the flash directory. If desired, you can use FTP or TFTP to copy the file to
another destination.
Usage Guidelines
This command displays the output of the multiple mesh and debug CLI commands, then saves that data into a
report file on the controller’s flash drive, where it can be analyzed for debugging purposes. The information in
this report includes the output of the following commands:
l show ap mesh neighbors
l show ap mesh debug current-cluster
l show ap mesh debug provisioned-clusters
l show ap mesh debug counters
l show ap mesh debug forwarding-table
l show ap mesh debug meshd-log
l show ap mesh debug hostapd-log
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms This show command is
available in the base
operating system. Commands
to configure the mesh feature
require the Mesh license.
Config mode on master controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show ap mesh tech-support | 1074