Release Notes

1091 | show ap monitor stats Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
FRR FRER
--- ----
17 4
Handoff Assist
--------------
rssi-index cur-signal old-cur-signal
---------- ---------- --------------
0 51 0
High Throughput Parameters
--------------------------
ht-type primary-channel sec-channel gf-supported 40mhz-intolerance
------- --------------- ----------- ------------ -----------------
none 0 0 0 0
The output of this command includes the following information:
Column Description
retry
Percent of 802.11 retry frames sent because a client failed to send an ACK.
Low-speed
Percent of frames sent at a data rate of 18 Mbps or slower.
non-unicast
Percent of non-unicast frames
recev-error
Percent of error frames of all frames seen in the last second.
frag
Rate of fragmented packets, in frames per second
bwth
Current bandwidth, in bps.
avg-signal
Average signal-to-noise ratio over the interval since the AP’s last reset.
Low-signal
Lowest signal-to-noise ratio over the interval since the AP’s last reset.
high-signal
Highest signal-to-noise ratio over the interval since the AP’s last reset.
count
Number of packets seen on the AP over the interval since the AP’s last reset.
Duration
Time over which the AP has measured RSSI values.
tx
The total number of deauthorization frames sent to this MAC address for
containment in the interval from the AP’s last reset until the current timer tick.
old-tx
The total number of deauthorization frames sent to this MAC address for
containment until the previous timer tick.
rx
The total number of deauthorization frames spoofing the MAC address in the
interval from the AP’s last reset until the current timer tick.
old-rx
The total number of deauthorization frames sent to this MAC address for
containment until the previous timer tick.
FRR
Frame retry rate, in frames per second.
FRER
Frame error retry rate, in frames per second.
rssi-index
This value indicates the number of consecutive timer ticks over which the value
of the Receive Signal Strength Indicator (RSSI) of the client has reduced by
more than 3 units.