Release Notes

show ap port status
ap-name <ap-name>
bssid <bssid>
ip-addr <ip-addr>
ip6-addr <ip6-addr>
wired-mac <wired-mac>
Description
Shows the status of the AP's wired ports. The status is updated every 60 seconds.
Syntax
Parameter Description
ap-name <ap-name>
Name of the AP.
bssid <bssid>
BSSID of the AP.
ip-addr <ip-addr>
IP address of the AP.
ip6-addr <ip6-addr>
IPv6 address of the AP.
wired-mac <wired-mac>
MAC address of the AP.
Examples
The output of the command displays the wired port status of an APnamed LocalAP1. In this example, the
output is divided into multiple sections to fit better on the pages of this document. In the actual command-line
interface, it appears in a single long table.
(host) #show ap port status ap-name LocalAP1
AP "LocalAP1" Port Status (updated every 60 seconds)
--------------------------------------------------
Port MAC Type Forward Mode Admin Oper Speed Duplex 802.3az PoE
---- --- ---- ------------ ----- ---- ----- ------ ------- ---
0 00:1a:1e:10:05:1a GE N/A enabled up 1 Gb/s full N/A N/A
1 00:1a:1e:10:05:1b FE tunnel enabled up 100 Mb/s full N/A N/A
2 00:1a:1e:10:05:1c FE tunnel enabled down N/A N/A N/A N/A
3 00:1a:1e:10:05:1d FE N/A disabled down N/A N/A N/A N/A
STP TX-Packets TX-Bytes RX-Packets RX-Bytes
--- ---------- -------- ---------- --------
N/A 23697 3338307 27449 8471871
Forwarding 12185 6593226 18436 1758272
Disabled 0 0 0 0
Off 0 0 0 0
Command History
Version Modification
ArubaOS 6.2 Command introduced.
ArubaOS 6.3
A new column STP displays the spanning tree state of the wired port.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show ap port status | 1096