Release Notes

1371 | show interface gigabitethernet Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
show interface gigabitethernet
show interface gigabitethernet <slot/port>
Description
Displays information about a specified Gigabit Ethernet port.
Syntax
Parameter Description
counters
Displays L2 interface counters for the specified interface.
switchport
Displays L2 interface information.
untrusted-vlan
Displays port member vlan untrusted status.
xsec
Displays xsec configuration.
Examples
The example below shows the output of show interface gigabitethernet 1/0.
(host)# show interface gigabitethernet 1/0
GE 1/0 is up, line protocol is up
Hardware is Gigabit Ethernet, address is 00:0B:86:F0:33:E1 (bia 00:0B:86:F0:33:E1)
Description: GE1/0 (RJ45 Connector)
Encapsulation ARPA, loopback not set
Configured: Duplex (AUTO ), speed (AUTO )
Jumbo Support is enabled on this interface MTU 9216
Negotiated: Duplex (Full), speed (100 Mbps)
MTU 1500 bytes, BW is 100 Mbit
Last clearing of "show interface" counters 23 day 4 hr 27 min 54 sec
link status last changed 15 day 3 hr 15 min 21 sec
2049219 packets input, 112651020 bytes
Received 911909 broadcasts, 0 runts, 0 giants, 0 throttles
26 input error bytes, 0 CRC, 0 frame
906926 multicast, 1137310 unicast
185897 packets output, 58327172 bytes
0 output errors bytes, 0 deferred
0 collisions, 0 late collisions, 0 throttles
This port is TRUSTED
POE Status of the port is ON
Jumbo frame support is enabled
The output of this command includes the following parameters:
Parameter Description
GE 1/0 is...
Displays the status of the specified port.
line protocol is...
Displays the status of the line protocol on the
specified port.
Hardware is....
Describes the hardware interface type.
address is...
Displays the MAC address of the hardware
interface.
Description
The port type, name, and connector type.