Release Notes

ap enet-link-profile
ap enet-link-profile <profile>
clone <profile>
dot3az
duplex {auto|full|half}
no ...
speed {10|100|1000|auto}
Description
This command configures an AP Ethernet link profile.
Syntax
Parameter Description Range Default
<profile>
Name of this instance of the profile. The name
must be 1-63 characters.
— “default”
clone
Name of an existing Ethernet Link profile from
which parameter values are copied.
— —
dot3az
Enable support for the 803.az Energy Efficient
Ethernet (EEE) standard, which allows the APs
to consume less power during periods of low
data activity.
Only W-AP130 Series APs support this feature.
If this feature is enabled for an APs group, any
APs in the group that do not support 803.az
will ignore this setting.
disabled
duplex
The duplex mode of the Ethernet interface,
either full, half, or auto-negotiated.
full/half/auto auto
no
Negates any configured parameter. — —
speed
The speed of the Ethernet interface, either 10
Mbps, 100 Mbps, 1000 Mbps (1 Gbps), or
auto-negotiated.
10/100/1000/auto auto
Usage Guidelines
This command configures the duplex and speed of the Ethernet port on the AP. The configurable speed is
dependent on the port type.
Example
The following command configures the Ethernet link profile for full-duplex and 100 Mbps:
ap enet-link-profile enet
duplex full
speed 100
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide ap enet-link-profile | 148