Release Notes

Parameter Description Range Default
wpa-hexkey
Configures a WPA pre-shared key. — —
wpa-passphrase
Sets the WPA password that generates the PSK. — —
Usage Guidelines
Mesh cluster profiles are specific to mesh nodes (APs configured for mesh) and provide the framework of the
mesh network. You must define and configure the mesh cluster profile before configuring an AP to operate as
a mesh node.
You can configure multiple mesh cluster profiles to be used within a mesh cluster. You must configure different
priority levels for each mesh cluster profile. See ap-group or ap-name for more information about priorities.
Cluster profiles, including the “default” profile, are not applied until you provision your APs for mesh.
Example
The following command configures a mesh cluster profile named “cluster1” for the mesh cluster
“headquarters:”
ap mesh-cluster-profile cluster1
cluster headquarters
Related Commands
To view a complete list of mesh cluster profiles and their status, use the following command:
show ap mesh-cluster-profile
To view the settings of a specific mesh cluster profile, use the following command:
show ap mesh-cluster-profile <name>
Command History
This command was introduced in ArubaOS 3.2.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system. Config mode on master controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide ap mesh-cluster-profile | 162