Release Notes

show remote-node-dhcp-pool (deprecated)
show remote-node-dhcp-pool <remote-node-profile-name>
Description
The output of this command lists shows Remote Node DHCP pool summary information.
Syntax
Parameter Description
remote-node-profile-name
Name of the Remote Node profile
Usage Guidelines
Each Remote Node profile contains a Remote Node DHCP address pool, which defines a range of IP addresses
allocated for Remote Node controllers at a remote site, and the VLAN to be associated with those addresses. A
remote-node dhcp pool is configured in the remote-note mode.
Use the show remote-node-dhcp-pool command to view a summary of Remote Node address pool
information.
Example
This example shows a summary of Remote Node DHCP address pool information.
(host) #show remote-node-dhcp-pool pool1
Remote Node Address Pools
--------------------------------------
Pool Name Type Start IP Address End IP Address Domain Name Num Hosts
--------- ---- ---------------- -------------- ----------- ---------
The output of this command includes the following parameters:
Parameter Description
Pool Name
Name of the new DHCP pool.
Type
Type of pool. This can be tunnel or vlan.
Start IP Address
IP addresses at the start and end of the Remote Node’s address range, in dotted-decimal
format.
End IP Address
IP address at the end of the Remote Node’s address range, in dotted-decimal format.
Domain Name
The DHCP domain name.
Num Hosts
Maximum number of hosts supported by a Remote Node using this pool.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show remote-node-dhcp-pool (deprecated) | 1622