Release Notes

1641 | show rf dot11g-radio-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
RX Sensitivity Threshold 0 -dBm
Non 802.11 Interference Immunity Level-2
Enable CSA Disabled
CSA Count 4
Management Frame Throttle interval 1 sec
Management Frame Throttle Limit 20
ARM/WIDS Override Disabled
Reduce Cell Size (Rx Sensitivity) 0 dB
Protection for 802.11b Clients Enabled
Adaptive Radio Management (ARM) Profile default
High-throughput Radio Profile default-g
Maximum Distance 0 meters
Spectrum Monitoring Disabled
Spectrum Monitoring Profile default-a
AM Scanning Profile default
The output of this command includes the following parameters:
Parameter Description
Radio enable Shows if the AP has enabled or disabled transmissions on this radio band.
Mode Access Point operating mode. Available options are:
l am-mode: Air Monitor mode
l ap-mode: Access Point mode
l apm-mode: Access Point Monitor mode
l sensor-mode: RFprotect sensor mode
High throughput enable
(radio)
Shows if high throughput (802.11n) is enabled or disabled on this radio.
A high-throughput profile manages 40 Mhz tolerance settings, and controls
whether or not APs using this profile will advertise intolerance of 40 MHz
operation. (This option is disabled by default, allowing 40 MHz operation.)
A high-throughput profile also determines whether an AP radio using the
profile will stop using the 40 MHz channels surrounding APs or stations
advertise 40 Mhz intolerance. This option is enabled by default.
Channel Channel number for the AP 802.11a/802.11n physical layer.
Beacon Period Time, in milliseconds, between successive beacon transmissions. The
beacon advertises the AP’s presence, identity, and radio characteristics to
wireless clients.
Beacon Regulate If enabled, this option introduces randomness in the beacon generation so
that multiple APs on the same channel do not send beacons at the same
time, which causes collisions over the air. This option is disabled by default.
Transmit EIRP Maximum transmit power (EIRP) in dBm from 0 to 51 in .5 dBm increments.
Further limited by regulatory domain constraints and AP capabilities.
Advertise 802.11d and
802.11h Capabilities
If enabled, the radio advertises its 802.11d (Country Information) and
802.11h (Transmit Power Control) capabilities.
TPC Power The transmit power advertised in the TPC IE of beacons and probe
responses
Spectrum load balancing The Spectrum load balancing feature helps optimize network resources by
balancing clients across channels, regardless of whether the AP or the
controller is responding to the wireless clients' probe requests.